Operator's Manual

45
3. Loosen screw on tie rod clamp (Fig. 63). Rotate ball
joint in or out to adjust length of tie rod.
4. Reinstall ball joint to mounting bracket and check
wheel toe-in.
5. After attaining desired adjustment, tighten screw on tie
rod clamp and re–secure ball joint to mounting bracket.
Adjusting Rear Wheel Toe–in
(Models 30626 & 30630 only)
The rear wheels should not toe–in or toe–out when they are
adjusted correctly. To check the rear wheel toe–in, measure
the center–to–center distance at wheel hub height, in front
and in back of the rear tires. If the wheels toe–in or toe–out,
an adjustment is required.
1. Rotate the steering wheel so rear wheels are straight
ahead.
2. Loosen the jam nuts on both tie rods Adjust both tie
rods until center-to-center distance at front and back of
rear wheels is the same (Fig. 64).
3. When rear wheels are adjusted correctly, tighten jam
nuts against tie rods.
1
Figure 64
1. Steering plate
Adjusting the Rear Wheel
Bearings
(Models 30626 & 30630 only)
1. Jack up rear of machine until wheel is off shop floor.
Use jack stands or block the machine to prevent it from
accidentally falling.
2. Remove dust cap from end of wheel spindle. Also
remove cotter pin securing retainer (Fig. 65).
1
3
4
2
5
Figure 65
1. Dust cup
2. Cotter pin
3. Nut retainer
4. Jam nut
5. Flatwasher
3. Tighten the jam nut (Fig. 65) to approximately
75–100 in–lbs using a hand wrench.
4. Turn the wheel hub to seat the bearings.
5. Loosen the jam nut until it is away from the flatwasher
and the wheel hub has end play.
6. Tighten the jam nut to 15–20 in–lbs while rotating the
the wheel hub.
7. Place the nut retainer over the jam nut. If the cotter pin
hole is not aligned with the retainer slot, remove the
retainer nut and reorientate until alignment occurs.
8. Insert cotter pin. The wheel hub must not have any free
play.
9. Install dust cap on end of wheel spindle.
10. Remove jack stands and lower machine to shop floor.
Adjusting the Brakes
Adjust the service brakes when there is more than 1 in.
(25 mm) of “free travel” of the turn pedals, or when the
brakes do not work effectively. Free travel is the distance
the brake pedal moves before braking resistance is felt.
The brakes should only need adjusting after considerable
use. These periodic adjustments can be performed where
the brake cables connect to the brake pedal mount. When
the cables are no longer adjustable, the star nut on the
inside of the brake drum must be adjusted to move the
brake shoes outward. However, the brake cables must be
adjusted again to compensate for this adjustment.