Operator's Manual

19
Installing the Steering Wheel
1. Move rear wheels so they point straight ahead.
2. Remove jam nut from steering shaft. Slide foam seal
and steering wheel onto steering shaft (Fig. 5).
1
2
3
4
5
Figure 5
1. Steering wheel
2. Jam nut
3. Cap
4. Screw
5. Foam seal
3. Secure steering wheel to shaft with jam nut and tighten
it to 10–15 ft.-lb.
4. Install cap to steering wheel with screw (Fig. 5).
Removing the Battery from the
Chassis
1. Release the two latches holding instrument cover in
place. Carefully remove instrument cover to expose the
battery.
2. Remove two wing nuts and hold down strap that secures
battery (Fig. 6). Lift battery out of chassis. Keep wing
nuts and hold down strap in safe place for later use.
1
2
1
3
4
Figure 6
1. Wing nuts
2. Hold down strap
3. Positive terminal
4. Negative terminal
Installing the Seat
The machine is shipped without the seat assembly. Either
optional Seat Kit, Model No. 30623 or 30625 must be
installed.
Seat Kit, Model No. 30623, Standard Seat
1. Loosely secure (2) R-clamps to right side of seat bottom
with 2 capscrews and flat washers supplied in kit
(Fig. 7). Install manual tube into R-clamps and tighten
capscrews (Fig. 7).
1
2
3
4
Figure 7
1. R-clamps
2. Seat support
3. Manual tube
4. Cap
2. Mount seat pivot bracket to frame with 2 flange screws
supplied in kit (Fig. 8)
1
Figure 8
1. Seat pivot bracket
3. Mount seat and seat support to seat pivot bracket with
pivot shaft and roll pin (Fig. 9).