Operator's Manual

13
Assembly
Note: Determine the left and right sides of the machine
from the normal operating position.
Loose Parts
Note: Use the chart below to verify that all parts have been shipped.
Description Qty. Use
Spacer
Steering wheel
Roll pin, 1/4 x 2-1/2 in.(64 mm)
1
1
1
Installing the steering wheel
Seat
Bolt, 5/16-18 x 1 in. (25 mm)
Lock nut, 5/16
R-clamp
1
4
4
1
Installing the seat
Weight
Bolt, 1/2 x 3-1/2 in. (89 mm)
Washer, 1/2 in. (13 mm)
Lock washer, 1/2 in. (13 mm)
Nut, 1/2 in.
2
4
4
4
4
Installing the rear weight
Carriage bolt, 1/4-20 x 3/4 in. (19 mm)
Wing nut, 1/4
2
2
Installing the battery cables
Parts catalog 1
Operator’s Manual 1 Read before operating the machine.
Registration card 1 Fill out and return to Toro.
Installing the Seat
1. Position the seat assembly onto the seat plate, aligning
the mounting holes (Fig. 1).
2. Slide the wire clamp over the seat switch wire (Fig. 1).
3. Using the left front hole, loosely secure the wire clamp
and seat to the seat base with capscrews and locknuts
(Fig. 1).
4. Mount the seat to the seat base with the 3 remaining
bolts and locknuts.
5. Route the seat switch wire through the slot in the seat
plate and plug the connector onto the seat switch
(Fig. 1).
6. Tighten all locknuts and check the operation of the seat.
7. Make sure the wire harness is clear of the lift arm and
all moving parts.
M–4264
1
2
3
4
Figure 1
1. Seat plate
2. R-clamp
3. Seat switch wire
4. Seat switch connector