Operator's Manual
Table Of Contents
- NO TITLE
- NO TITLE
- 1 Installing the Lift Arms
- 2 Installing the Carrier Frame
- 3 Installing the Cutting Unit
- 4 Installing the CE Decal
- 5 Installing Rear Weight
- NO TITLE
- NO TITLE
- Lubrication
- Separating the Cutting Unit from the Traction Unit
- Servicing the Bushings in the Castor Arms
- Servicing the Castor Wheel and Bearing
- Checking for a Bent Blade
- Removing the Cutting Blade
- Inspecting and Sharpening the Blade
- Checking and Correcting Mismatch of Blades
- Replacing the Grass Deflector
- Adjusting the Idler Pulley
- Replacing the Drive Belt
Maintenance
Important:Thefastenersonthecoversofthismachine
aredesignedtoremainonthecoverafterremoval.
Loosenallofthefastenersoneachcoverafewturnsso
thatthecoverisloosebutstillattached,thengoback
andloosenthemuntilthecovercomesfree.Thiswill
preventyoufromaccidentallystrippingtheboltsfree
oftheretainers.
Lubrication
Thecuttingunitmustbelubricatedregularly.Ifthemachine
isoperatedundernormalconditions,lubricatethecastor
bearingsandbushingswithNo.2generalpurposelithium
basegreaseormolybdenumbasegreaseafterevery8hoursof
operationordaily,whichevercomesrst.Allotherbearings,
bushings,andthegearboxmustbelubricatedafterevery50
hoursofoperation.
1.Lubricatethefollowingareas:
•castorspindlebushings(
Figure13)
•castorwheelbearings(Figure13)
Figure13
•rightandleftliftarmpivotpins(Figure14)
Figure14
•bladespindlebearings(Figure15)
Figure15
2.Positionthemachineandcuttingunitonalevelsurface
andlowerthecuttingunit.Removethedipstick/ll
plugfromthetopofthegearbox(Figure16)and
makesurethatthelubricantisbetweenthemarkson
thedipstick.Ifthelubricantlevelislow,addSAE
80-90wt.gearlubeuntilthelevelisbetweenthemarks.
SAE80-90wt.syntheticgearlubemaybeusedasan
alternative.
Figure16
14