Service Manual

Groundsmaster 360Operator Cab Page 8.1 − 22
(Rev. A)
Blower Fan
1. Mixing box
2. Rivet (19)
3. Mixing box cover
4. Cover insulation
5. Heater core/AC evaporator assembly
6. O−ring (2)
7. Expansion valve
8. Blower fan
9. Screw (6)
10. Freeze switch
11. Screw (2)
12. Air diverter assembly
13. AC hose (from drier−receiver)
14. O−ring
15. AC hose (to AC compressor)
16. O−ring
Figure 14
2
3
6
8
9
10
11
1
5
7
12
4
FRONT
RIGHT
13
14
15
16
(21 to 27 N−m)
15 to 20 ft−lb
NOTE: The blower fan can be removed and installed
with the mixing box (item 1 in Figure 14) attached to the
cab headliner.
Removal (Fig. 14)
1. Park machine on a level surface, lower cutting deck
or implement and stop engine. Remove key from the
ignition switch.
2. To access blower fan, remove roof panel from top of
cab (see Roof Assembly in this section).
3. Read the General Precautions for Removing and
Installing Air Conditioning System Components at the
beginning of the Service and Repairs section of this
chapter.
CAUTION
The air conditioning system is under high pres-
sure. Do not loosen any system fitting or compo-
nent until after the system has been completely
discharged by a certified A/C service technician.