Service Manual

Groundsmaster 360 Operator CabPage 8.1 − 25
(Rev. A)
Disassembly (Fig. 16)
1. Park machine on a level surface, lower cutting deck
or implement and stop engine. Remove key from the
ignition switch.
2. To remove wiper blade, remove two (2) cap screws
and lock washers that secure wiper blade to wiper arm
assembly.
3. If necessary, remove wiper arm assembly:
A. Disconnect washer hose from wiper assembly.
B. Lift caps at top of wiper arms and remove flange
nuts that secure wiper arms to wiper motor.
C. Use suitable puller to remove tapered wiper arm
sockets from wiper motor shafts.
4. If access to wiper motor is necessary, remove roof
panel from top of cab to allow access to wiper motor as-
sembly (see Roof Assembly in this section). Remove
wiper motor components using Figure 16 as a guide.
Assembly (Fig. 16)
1. If required, install removed wiper motor components
using Figure 16 as a guide.
A. If wiper bracket (item 8) was removed, apply
bead of RTV sealant around wiper opening on inside
of headliner before installing bracket.
B. If jam nut (item 16) was removed, torque jam nut
to 100 in−lb (11.3 N−m) during assembly.
C. Make sure that wiper motor electrical connector
is secured to cab wire harness.
D. Secure roof panel to top of cab (see Roof Assem-
bly in this section).
2. If wiper blade was removed, apply medium strength
thread locker to threads of cap screws (item 2). Secure
blade to wiper arm assembly with two (2) cap screws
and lock washers.
3. If wiper arm assembly was removed:
A. Clean tapered wiper arm sockets and wiper mo-
tor shafts.
B. Run the wiper motor for one (1) cycle to allow the
motor to return to the normal OFF position.
C. Slide wiper arm sockets onto wiper motor shafts
so that the bottom of the wiper blade is 3 inches (76
mm) from the right side window trim (Fig. 17).
D. Secure wiper arm sockets to motor shafts with
flange nuts. Torque nuts from 16 to 18 ft−lb (23 to 25
N−m).
E. Install wiper arm caps over flange nuts.
F. Connect washer hose to wiper assembly.
Figure 17
(76 mm)
3 inches
Operator
Cab