Service Manual

Groundsmaster 360 Hydraulic SystemPage 4 − 103

50.Lubricate solenoid valve spring, sleeve and spool

with clean hydraulic oil and install into pump body. Make

sure that sleeve is installed so that holes are closest to

the spring location and that step in spool is toward spring

location as well. Place pin in spool.

51.Install solenoid valve stem into pump body and

torque from 186 to 195 in−lb (21 to 22 N−m).

52.Place O−ring, solenoid coil, O−ring, washer, lock

washer and nut onto solenoid valve stem. Coil should be

installed so the “KANZAKI” molded into the coil has the

“I” nearest the nut location (Fig. 125). Torque nut from 53

to 69 in−lb (5.9 to 7.8 N−m).

1. Sleeve

2. Spool

3. Pin

4. Sleeve holes

5. Spool step

6. Solenoid valve stem

7. Solenoid coil

Figure 124

1. Hex nut

2. Lock washer

3. Washer

4. Seal

5. Solenoid valve coil

6. Letter I

Figure 125

53 to 69 in−lb

(5.9 to 7.8 N−m)

Hydraulic

System