Service Manual

Groundsmaster 360Hydraulic System Page 4 − 96

10.Install clutch assembly and gear onto PTO shaft:

A. Install key into PTO shaft slot making sure that

rounded ends of key align with rounded ends of shaft

slot.

B. Slide clutch assembly and gear onto PTO shaft

making sure to align slot in clutch with key in shaft.

Also, align rods in clutch with holes in B−plate.

C. Place spacer onto PTO shaft.

D. Press bearing onto PTO shaft so bearing is flush

with shaft shoulder.

1. Bearing

2. PTO shaft

3. Spacer

4. Gear

5. Clutch assembly

6. Key

Figure 104

11.Apply clean hydraulic oil to friction plate and place in

transmission pump housing. Make sure that tabs on fric-

tion plate are placed in housing grooves.

1. Friction plate 2. Pump housing

Figure 105

12.Install PTO shaft assembly into transmission pump

housing. Make sure that tabs on friction plates are

placed in housing grooves.

1. PTO shaft assembly

2. Pump housing

3. Friction plate tabs

4. Housing groove

Figure 106