Service Manual

Groundsmaster 360Hydraulic System Page 4 − 88

28.Remove two (2) hex plugs and one (1) socket head

plug from gear case housing. Remove and discard O−

rings from plugs.

1. Hex plug 2. Socket head plug

Figure 85

29.Remove fifteen (15) flange head screws that secure

gear case housing to transmission pump housing.

30.Carefully remove gear case housing from pump

housing.

31.Locate and retrieve two (2) pins from gear case

housing holes. Remove and discard gasket.

32.Remove retaining ring that secures input shaft oil

seal into gear case housing bore. Remove spacer and

oil seal from housing taking care to not damage seal

bore in housing. Discard seal.

1. Gear case housing

2. Pump housing

3. Pin (2)

Figure 86