Operator's Manual

15
m–5998
3
1
2
5
4
7
6
Figure 7
1. Left handle shown
2. Neutral lock
3. Clevis pin
4. Drive lever
5. Control rod
6. Operator Presence
Control lever (OPC)
7. Hairpin cotter
4. Thread rod fittings equal distance onto each control rod.
For a starting point, thread rod fittings onto control rod
approximately 2–1/2 inch (64 mm) from the bottom
(Fig. 8).
5. Install rod fittings to idler brackets with clevis pins and
e–ring (Fig. 8).
m–5400
4
2
1
3
5
Figure 8
1. Control rod
2. Idler bracket
3. Rod fitting
4. E–ring
5. 2–1/2 inch (64 mm) from
bottom
Installing the Control Arm
Rods
1. Insert control arm swivel thru hole in speed control
crank and secure with hairpin cotter (Fig. 9).
1
2
3
m–5994
Figure 9
1. Control arm
2. Swivel
3. Speed control crank
2. Repeat this procedure for the opposite side.
Installing the Speed Control
Rod
1. Move the speed control lever fully forward (Fig. 10).
1
m–6487
Figure 10
1. Speed control lever