Service Manual

ELECTRICAL

9-7Floating Deck Mid-Size Service Manual

7. Set the Volt/Ohm meter to the OHMs setting. Con-

nect a test lead to the green wire at the module

connector. Connect the other test lead to the engine

block (Fig. 1411). The reading should be 2.8 OHMs.

A higher reading indicates a poor connection on the

green wire, the clutch or ground. Clean and secure all

connection points.

A lower reading indicates a problem with the clutch coil.

Fig 1411 IMG_8056a

5. Move the bail to the operation position and tempor-

arily tie it in place (Fig. 1409).

6. Attach the test lead to the brown wire and pull the

clutch switch, the voltage should not change (Fig.

1410).

If the voltage does change: Trace the problem back

through the wire harness and switches.

If the voltage does NOT change: Check the PTO clutch

and module ground connections, step 7 and 8.

Fig 1409 IMG_8066a

Fig 1410 IMG_8051a