Service Manual

________________________________________________________________________________________________________________________________________________________
________________________________________________________________________________________________________________________________________________________
Specifications
Item Specification
PTO Clutch air gap 0.011 - 0.021 inches
Belt adjustment 180 ft-lb torque
(2
0 inch long torque wrench
in square hole of clutch plate)
Special Tools
Order special tools from TORO SPECIAL TOOLS AND
Some tools may be listed in the Groundsmaster 455-D
APPLICATIONS GUIDE (Commercial Products)
. Parts Catalog. Tools may also be available from a local
supplier.
Bearing Locknut Wrench (TOR4050)
Use this tool (TOR4050) to remove and install the PTO
drive pulley bearing locknut (Fig. 6, Item 1).
Bearing Locknut Wrench (TOR4051)
Use this tool (TOR4051) to remove and install the PTO
lower driven pulley bearing locknut (Fig. 10, Item 30).
Specifications Page 7 - 2
Re
v. A
Groundsmaster
®
455-D