Operator's Manual
!" "
Thoroughly clean the traction unit, cutting units
and the engine.
Check the tire pressure. Inflate all tires to 20 psi.
Check all fasteners for looseness; tighten as
necessary.
Grease or oil all grease fittings and pivot points.
Wipe up any excess lubricant.
Lightly sand and use touch-up paint on painted
areas that are scratched, chipped, or rusted. Repair
any dents in the metal body.
Service the battery and cables as follows:
a. Remove the battery terminals from the battery
posts.
b. Clean the battery, terminals, and posts with a
wire brush and baking soda solution.
c. Coat the cable terminals and battery posts with
Grafo 112X skin-over grease (Toro Part No.
505Ć47) or petroleum jelly to prevent corrosion.
d. Slowly recharge the battery every 60 days for 24
hours to prevent lead sulfation of the battery.
Drain the engine oil from the oil pan and replace
the drain plug.
Remove and discard the oil filter. Install a new oil
filter.
Refill oil pan with 5.3 quarts of SAE15WĆ40 CD
motor oil.
Start the engine and run at idle speed for
approximately two minutes.
Stop the engine.
Flush the fuel tank with fresh, clean diesel fuel.
Re-secure all fuel system fittings.
Thoroughly clean and service the air cleaner
assembly.
Seal the air cleaner inlet and the exhaust outlet with
weatherproof tape.
. Check anti freeze protection and add a 50/50
solution of water and Peugeot recommended anti
freeze (Toro part No. 93-7213) as needed for
expected minimum temperature in your area.