Service Manual

Groundsmaster 4100--D/4110--D Hydraulic SystemPage 4 -- 51
Procedure for Cutting Deck Circuit Pressure Test
1. Make sure hydraulic oil is at normal operating tem-
perature by operating the machine under load for
approximately ten (10) minutes. Make sure the hydrau-
lic tank is full.
2. Parkmachineonalevels urface withthe cuttingdeck
lowered and off. Make sure engine is offand the parking
brake is engaged.
CAUTION
Prevent personal injury and/or damage to equip-
ment. Read all WARNINGS, CAUTIONS and Pre-
cautions for Hydraulic Testing at the beginning
of this section.
3. Install 5000 PSI (350 bar) pressure gauge with hy-
draulic hose attached to PTO manifold test port for the
deck to be tested (Fig. 37, 38 or 39).
4. After installing pressure gauge, start engine and run
at idle speed. Check for hydraulic leakage at pressure
gauge location and correct before proceeding with test.
CAUTION
Cutting deck blades will rotate with PTO switch
inON position. Keep awayfrom cutting deck dur-
ing test to prevent personal injury from rotating
blades. Do not stand in f ront of the machine.
5. Move throttle so engine is running at high idle speed
(2870 RPM). Engage the cutting deck.
6. Watch pressure gauge carefully while mowing with
the machine.
7. Cutting deck c ircuit pressure should be as follows
and will vary depending on mowing conditions:
LH Wing Deck: 1000 to 3000 PSI (69 to 207 bar)
Center Deck: 1000 to 3000 PSI (69 to 207 bar)
RH Wing Deck: 1000 to 2000 PSI (69 to 137 bar)
8. Disengage cutting deck and shut off engine. Record
test results.
9. When testing is c ompleted, disconnect test gauge
with hose from manifold test port.
1. Center deck hydraulic manifold
2. Center deck circuit pressure test port
Figure 37
1
2
1. Right wing deck circuit pressure test port
Figure 38
1
1. Left wing deck circuit pressure test port
Figure 39
1
Hydraulic
System