Service Manual

Groundsmaster 4000--D/4010--D Page 5 -- 45 Electrical System

B. Make sure that ignition switch is OFF and discon-

nect the switch connector from wire harness.

C. Using a multimeter, verify that wire harness con-

nector terminal for pink wire has 12 VDC when the

ignition switch is ON.

D. Make sure that clearance between end of posi-

tion switch and sensing plate is from 0.070” and

0.130” (1.8 to 3.3 mm). If necessary, adjust position

switch (see Cutting Deck Position Switches in the

Adjustments section of this chapter). Recheck

switch operation after adjustment.

E. Ifpink wirehas systemvoltagepresentandgapis

correctbut switch LED did not function,replace posi-

tion switch.

6. After testing is complete, make sure that position

switch connector is plugged into wire harness.

1. Side position switch

2. Sensing plate

3. Switch LED location

Figure 61

Electrical

System