Operator's Manual

22
Step
10
Setting Up the Hydro Linkage
Parts needed for this step:
None
Procedure
Check the following adjustments when the machine is first
set up and adjust only as needed. Do them in the order that
they are listed here.
Checking the Speed Control Linkage
Refer to Adjusting the Speed Control Linkage on page 42.
Checking the Temporary Neutral Stud
Adjustment
Refer to Temporary Neutral Stud Adjustment on page 43.
Checking the Hydro Control Linkages
Refer to Adjusting the Hydro Control Linkages on
page 43.
Checking the Neutral Stud
Refer to Adjusting the Neutral Stud on page 45.
Checking the Control Rods
Refer to Adjusting the Control Rods on page 46.
Checking the Tracking
Refer to Adjusting the Tracking on page 47.
Operation
Note: Determine the left and right sides of the machine
from the normal operating position.
Think Safety First
Carefully read all the safety instructions and decals in the
safety section. Knowing this information could help you,
your family, pets or bystanders avoid injury.
The use of protective equipment for eyes, hearing, feet
and head is recommended.
This machine produces sound levels in excess of
85 dBA at the operator’s ear and can cause
hearing loss through extended periods of
exposure.
Wear hearing protection when operating this
machine.
Caution
1
2
Figure 15
1. Caution 2. Wear hearing protection
Controls
Become familiar with all the controls (Fig. 16) before you
start the engine and operate the machine.
Throttle control – The throttle control has three
positions: Choke, Fast and Slow.
Operator Presence Control (OPC) levers – OPC levers
are used in conjunction with deck engagement switch
(PTO) to release blade brake and engage clutch to drive
mower blades. Release OPC levers to disengage mower
blades.
Blade control switch (PTO) – Pull switch used in
conjunction with OPC levers to release blade brake and
engage clutch to drive mower blades.
Speed control lever – This machine has a variable speed
control with a neutral position. This controls and limits
how fast the machine will travel.