Service Manual

Table Of Contents
Groundsmaster 7200/7210 Hydraulic SystemPage 4 – 63
33.Remove input shaft, RH pump shaft and LH pump
shaft assemblies from transmission pump housing.
34.Slide pipe assembly from bore of pump housing. Re-
move and discard two (2) O–rings from grooves in pipe.
1. Input shaft
2. RH pump shaft
3. LH pump shaft
4. Pipe
Figure 56
3
1
4
2
35.If pump shaft bearing replacement is necessary, re-
move and discard seal ring from RH and LH pump
shafts. Remove bearings from pump shaft using a bear-
ing puller. Discard removed bearings. Remove gear
from pump shaft.
36.If input shaft bearing replacement is necessary, re-
move bearings from input shaft using a bearing puller.
Discard removed bearings. Remove gear from input
shaft.
1. RH pump shaft
2. LH pump shaft
3. Input shaft
4. Seal ring
Figure 57
3
1
4
2
4
Hydraulic
System