Service Manual

Mid-Size Walk Behind Service Manual 6 - 5
GEAR DRIVE TRANSMISSION
Control Linkage Removal (T-Bar)
1. Disconnect wiring for operator presence control
(OPC) switch from T-Bar.
2. Disconnect the plug from the OPC switch (Figure
133).
Figure 133
0819-28
3. Remove the spade connectors from the plastic
plug by depressing the connector lock with a
paper clip or special tool (Figure 134). NOTE:
When assembled, the orange wire should be on
the operator’s right.
Figure 134
0819-11
4. Pull the wire harness from the tube in the T-Bar
(Figure 135).
Figure 135
0819-15
5. Remove the cotter pins connecting the link to the
T-Bar. This will also allow removal of the OPC
handle (Figure 136).
Figure 136
0819-10