Operator's Manual

27
Servicing the Air Cleaner
Service Interval/Specification
Foam element: Clean it after every 25 operating hours.
Paper element: Replace it after every 200 operating hours
or yearly, which ever comes first.
Note: Service the air cleaner more frequently (every few
operating hours) if the operating conditions are extremely
dusty or sandy.
Important Do not oil the foam or paper element.
Removing the Foam and Paper Elements
1. Disengage the PTO and set the parking brake.
2. Stop the engine, remove the key, and wait for all
moving parts to stop before leaving the operating
position.
3. Clean around the air cleaner to prevent dirt from getting
into the engine and causing damage (Fig. 27).
4. Unscrew the cover knob and remove the air cleaner
cover (Fig. 27).
5. Unscrew the 2 wing nuts and remove the air cleaner
assembly (Fig. 27).
6. Carefully pull the foam element off the paper element
(Fig. 27).
m–7452
2
3
4
5
1
6
Figure 27
1. Engine
2. Cover
3. Wing nut
4. Foam element
5. Paper element
6. Cover knob
Cleaning the Foam Element
1. Wash the foam element in liquid soap and warm water.
When the element is clean, rinse it thoroughly.
2. Dry the element by squeezing it in a clean cloth.
Important Replace the foam element if it is torn or
worn.
Inspecting the Paper Element
Important Never clean the paper element with
pressurized air or liquids, such as solvent, gas, or kerosene.
1. Inspect the element for tears, an oily film, and damage
to the rubber seal.
2. Replace the paper element if it is damaged or
excessively dirty.