Operator's Manual

16
m–3771
1
2
3
5
4
6
3
Figure 5
1. Bolt, 5/16 x 7/8 inch
2. Lock washer, 5/16 inch
3. Washer, 5/16 inch
4. Stud
5. Spring
6. Locknut
4. Slide the hose clamp onto the fuel line (Fig. 6).
5. Push the fuel line onto the fuel tank connection and
secure it with a hose clamp (Fig. 6).
3
2
1
m–6442
Figure 6
1. Fuel line
2. Hose clamp
3. Fuel fitting
Step
4
Checking and Adjusting the
Shift Lever Plate
Parts needed for this step:
None
Procedure
1. Shift lever to second gear and check alignment of lever
in slot of shifter lever plate. The clearance between top
and bottom of the shift lever should be equal (Fig. 8).
2. If clearance is not correct, remove lever and bend it
slightly to adjust (Fig. 8).
m–5250
1
2
6
5
4
3
Figure 7
1. Shift lever
2. Shift lever plate
3. Rubber seal washer
4. Square hole washer
5. Spring washer
6. Locknut, 3/8 inch
Note: Do not bend lever while attached to transmission
shaft or damage may occur.
3. Shift lever to neutral and check alignment of lever in
slot of shifter lever plate. The clearance on the sides of
shift lever should be equal (Fig. 8).
4. If clearance is not correct, loosen shift lever plate and
adjust it side–to–side. Tighten the shift lever plate.
4
Rear View
1
4
3
2
2
m–7454
Figure 8
1. Shift lever, 2nd gear
2. Shift lever plate
3. Shift lever, neutral
4. Equal distance