Operator's Manual

GREASING BEARINGS AND

BUSHINGS

The machine has grease fittings that must be lubricated regu-

larly with No. 2 General Purpose Lithium Base Grease. If

the machine is operated under normal conditions, lubricate

all bearings and bushings after every 50 hours of operation

or immediately after every washing.

The grease fitting locations and quantities are:

2-Wheel Drive Models only—Steering cylinder ball joints

(2), Rear axle tie rod (2), Rear axle pivot (1) Rear Spindle

Shafts (2) (Fig. 13).

4-Wheel Drive Models only—Steering cylinder ball joints

(2), Rear axle tie rod (2), Rear axle pivot (1), Double Cardan

joints (2 each side) (Fig. 14) and Rear DrIve Shaft (3) (Fig.

15)

All Models—Intermediate Drive Shaft (3) (Fig. 16); Pedal

Pivots (5), Traction pedal (In square tube under floor plate)

(1) (Fig. 17) and Lift arm pivot (2) (Fig. 18).

Figure 13

Figure 14

Figure 15

Figure 16

Figure 17

Figure 18

Maintenance