Service Manual

Remove Pump Cylinder Block Kit, Block Spring and Washer,
Swashplate and
Cradle Bearings from Housing
Remove Input Shaft Retaining Ring, Seal and Input Shaft
from Housing
Remove Bearing
from Input Shaft
Remove the thrust bearing from the swashplate.
Remove the pump swashplate from the housing.
Remove the swashplate cradle bearings from the
housing.
Remove the slot guide block from the displacement
control shaft.
Remove the input shaft seal retaining ring.
Carefully pull the input shaft
seal out of the housing bore.
A hook may be used to pry theseal out, or a slide hammer
type puller may
be used to remove the seal. Care must
be taken
so as not to damage the housing bore, shaft
sealing surface
or bearing. Once removed, theseal is not
reusable.
Remove the bearing spacer washer.
Remove the pump shaft and bearing assembly from the
housing.
Remove the outer bearing retaining ring (and washer,
if
used) and press the shaft out of the bearing.
NOTE: An inner bearing retaining ring is used on
most shafts. Remove it from the shaft if necessary.
BDP Service Manual Page 11