Installation Instructions

2
m–5220
3
8
7
3
6
2
1
5
4
10
9
Figure 2
1. Bolt, 5/16 x 7/8 in.
2. Lock washers, 5/16 in.
3. Washer, 5/16 in.
4. Fuel line
5. Hose clamp
6. Stud
7. Spring
8. Locknut
9. Control panel
10. Fuel tank connection
8. Slide the hose clamp onto the fuel line (Fig. 2).
9. Push the fuel line onto the fuel tank connection
and secure it with a hose clamp (Fig. 2).
10. Shift lever to second gear and check alignment
of lever in slot of control panel. Clearance
between top of lever and the top of the slot
should be about equal to the clearance between
bottom of the lever and the bottom of the slot.
11. If clearance is not correct, remove lever and bend
it slightly to adjust.
Note: Do not bend lever while attached to
transmission shaft or damage may
occur.