Service Manual
MOWER DECKS
7 - 18 Mid-Size Walk Behind Service Manual
Checking for Bent Blades
1. Rotate the blades until the ends face forward and
backward (Figure 188). Measure from a level
surface to the cutting edge, position A, of the
blades (Figure 189). Note this dimension.
Figure 188
m-1078
Figure 189 m-2539
2. Rotate the blades 180 degrees so that the
opposite ends are forward. Measure from a level
surface to the cutting edge of the blades as in step
1 above. The difference between the dimensions
must not exceed 1/8 in. (3mm). If this dimension
exceeds 1/8 in. (3mm), the blade is bent and must
be replaced. Refer to "Removing the Blades" on
page 7 - 18, and "Installing the Blades" on page 7
- 19.
Removing the Blades
Blades must be replaced if a solid object is hit, if the
blade is out of balance or is bent. To ensure optimum
performance and continued safety conformance of the
machine, use genuine Toro replacement blades.
Replacement blades made by other manufacturers
may result in non-conformance with safety standards.
WARNING
A blade that is bent or damaged could break apart
and could seriously injure or kill you or
bystanders.
• Always replace bent or damaged blade with a
new blade.
• Never file or create sharp notches in the edges
or surfaces of blade.