Service Manual

B. Assemble knuckle pin (Item 20) and knuckle case medium strenght Loctite on capscrews (Item 28)
(Item 38) to match knuckle arm (Item 8) with knuckle securing cover (Item 26).
pin. Fasten capscrew (Item 10) temporarily (will be
removed to fill with lubricant). F. Evenly tighten capscrews (Item 28, 39) securing
covers to a torque of 12 - 20 ft-lb (170-280 Kg-Cm).
C. Assemble wheel shaft (Item 35) to cover
(Item 30). 4. Install axle on machine (see Rear Axle Removal and
Installation).
D. Assemble gear (Item 5) to wheel shaft and install
cover and wheel shaft assembly to knuckle case 5. Fill axle with proper lubricant to level of check plugs
(Item 38). Note that top two (2) capscrews (Item 39), (see Specifications).
securing cover (Item 30) are a shorter length.
E. Install bevel gear (Item 5) to knuckle pin and install
cover (Item 26) to knuckle case (Item 38). Use
Groundsmaster
®
223-D Page 14 - 11
Rev. B
Repairs