Service Manual

Checking Gearbox Lubricant
The gear box in designed to operate on SAE 80–90 wt.
gear lube. Although the gear box is shipped with lubri-
cant from the factory, check the level before operating
the cutting unit.
1. Position the machine and cutting unit on a level sur-
face.
2. Remove check plug from side of gear box and make
sure lubricant is up to bottom of hole. If level of
lubricant
is low, remove fill plug on top of gear case and add
enough lubricant to bring it up to bottom of hole in side.
1
2
3
Figure 8
1. Filler Plug
2. Check Plug
3. Drain Plug
Groundsmaster 223–D
Page 15 – 9
Rev. B
Guardian 62 Recycler Cutting Unit