Service Manual

GEAR DRIVE TRANSMISSION
6 - 6 Mid-Size Walk Behind Service Manual
6. Remove the hairpin cotters and washers securing
the trunnions to the idler brackets (Figure 137).
Figure 137
0819-16
7. Remove the cotter pins from the T-Bar.
8. Remove the pivot pins securing the T-Bar to the
handle (Figure 138).
Figure 138
0819-12
Installation
Follow the removal procedures in reverse.
Control Linkage Adjustment
(T-Bar Gear Drive)
1. Check the initial adjustment of the control rods.
The control rods should be threaded through the
rod fittings approximately 3” (76mm) (Figure 139).
Figure 139
0819-17
2. Check the parking brake engagement. The
parking brake lever should swing into a snug
position against the upper handle while pulling
back on the upper control bar (Figure 140).
Figure 140
0819-09
3
”
(
7
6
m
m
)