Service Manual

Mid-Size Walk Behind Service Manual 6 - 1
GEAR DRIVE TRANSMISSION
Transmission Removal - Gear Drive
1. Raise the rear of the unit and place on safety
stands.
2. Remove the spring from the belt tensioning arm
(Figure 124).
3. Remove the pivot bolt and tensioning arm
assembly (Figure 124).
Figure 124
0819-35
4. Remove the external snap ring and loosen the
transmission pulley set screw (Figure 125).
Figure 125
0820-01
5. Slide the pulley off the transmission input shaft.
6. Remove the hairpin cotter and washer securing
the control rod to the idler bracket. Remove the
control rod from the bracket (Figure 126).
Figure 126
0819-16
7. Remove the hairpin cotter and washer from the
brake rod and remove the brake rod from the idler
bracket (Figure 127).
Figure 127
0820-07
(A) Set screw (B) Snap ring
A
B