Service Manual

ELECTRICAL
8 - 12 Mid-Size Walk Behind Service Manual
Switch (95-1653)
Purpose
Like the previously shown switch, this part is used to
determine if the parking brake is set and if the
transmission is in neutral.
Location
The location depends on the application. A parking
brake switch application will be located in or near the
brake linkage.
The same applies to the transmission application.
Common locations are under the control panel around
the upper handle or on the traction frame near the
transmission.
Figure 234
mvc-058x
Testing
This is a normally closed switch; when it is out in your
hand there will be continuity between the terminals.
Use a ohmmeter to determine if the contacts open and
close correctly.
Bail Switch (82-2190)
Purpose
This switch functions as an operator presence control.
The operator must maintain a grip on the T-bar to keep
the blade clutch running.
Location
The bail switch is located in the center of the T-bar on
the upper handle.
Figure 235
mvc-047x
Testing
Separate the switch from the wire harness. The switch
is normally open and closes when the bail is squeezed.
Attach an ohmmeter to the switch terminals to
determine if the contacts open and close correctly.
Rocker Switch (82-2300)
Purpose
This switch is part of the power supply circuit for the
electric clutch on T-bar models. It is depressed only
momentarily when you wish to engage the blade.