Operator's Manual

Set-Up
11
Install Shift Lever
1. Align mounting block with flats of shaft on top
of transmission and slide onto shaft (Fig. 1).
Note: DO NOT remove rubber washer on
transmission shaft.
2. Slide shift lever through control panel and align
mounting hole in lever with mounting block on
transmission. Secure lever to transmission with
2 in. (51 mm) bolt and washer. Torque bolt to
115 in. lb. (155 N.m).


m–2574


Figure 1
1. Mounting block
2. Shift lever
3. Bolt 1/4–28 x 2” (51 mm)
4. Washer
Mount Control Panel and Fuel
Tank
1. Slide control panel over shift lever and under
bottom of rear frame (Fig. 2). Align fuel tank to
top of rear frame (Fig. 2).
m–1716
1
2
3
Figure 2
1. Rear frame
2. Control panel
3. Fuel tank
2. Secure control panel and fuel tank to rear frame
with (4) 7/8 in. (22.5 mm) bolts, lock washers
and washers (Fig. 3).
Note: Place transmission in neutral. Align
control panel so there is 1/16 in.
(2 mm) space between panel and lever.
3. Slide hose clamp onto fuel line (Fig. 3). Push
fuel line onto fuel tank fitting and secure with
hose clamp (Fig. 3).
m–1717
1
2
3
5
4
6
Figure 3
1. Bolt 5/8–18 x 7/8”
(22.5 mm)
2. Lock washer
3. Washer
4.
Fuel line
5. Hose clamp
6. Fuel fitting