Service Manual
4-23
WPM Drive Systems Manual
SINGLESPEEDBEVELGEARTRANSMISSION
16. Push the transmission to the left, as shown, and
rotate to clear the tunnel. Drop the left side down,
then pull the assembly out to the left side (Fig. 104).
Fig102 MVC-211X1
15. Remove the nut, washer, 2 pulley halves, and
spacer from the transmission input shaft. Remove 2
screws securing the belt guide to the transmission
(Fig. 103).
Fig103 PICT-1926a
A. 2 screws on top D. Pulley half
of transmission E. Washer
B. Spacer F. Nut
C. Pulley half
A
B
C
D
E
F
Fig104 MVC-300X
17. The last step is to slide the bearings and bearing
retainers off the axle (Fig. 105).
Fig105 MVC-301X