Operator's Manual

10
Note: For easier adjustment, lift up the housing so that the
wheel is off the ground. Do not put your fingers under
housing to lift up the lawn mower.
3. Squeeze the cutting height lever toward the wheel and
move it to the desired setting (Fig. 12).
1
Figure 12
1. Cutting height lever
4. Engage the pin on the cutting height lever in the desired
notch.
5. Adjust all the wheels to the same setting.
Using the Grass Bag
Installing the Grass Bag
1. Wait for all moving parts to stop.
2. Raise the discharge door, slide the bag ramp attached to
the grass bag into the discharge opening, and hook the
bag frame onto the rounded portion of the mounting
brackets (Fig. 13).
775
1
2
3
4
5
6
Figure 13
1. Bag door
2. Bag ramp
3. Discharge door
4. Bag handle
5. Mounting bracket (2)
6. Bag frame hook (2)
Note: Ensure that the grass bag door is fully closed against
the grass bag before installing the bag.
3. Allow the discharge door to close on top of the grass
bag (Fig. 14).
795
Figure 14
Mowing with the Grass Bag
A worn grass bag could allow small stones and
other similar debris to be thrown in the operator’s
or bystander’s direction and result in serious
personal injury or death to the operator or
bystanders.
Check the grass bag frequently. If it is damaged,
install a new Toro replacement bag.
Warning