Service Manual

Alternator Coil and Starter Motor
1. If the engine is electric start, mount the
alternator coil on its bosses as shown in
Fig. 4-64.
Figure 4-61
Oil Fill Tube
1. Install “0” ring fully into the groove on the
oil fill tube. See Fig. 4-62.
Figure 4-64
r\ Figure 4-62
2. Mount the tube with two screws. Make sure
the“0” ring is not pinched between the tube
and the block of the engine.
Ignition Coil
1. Mount the ignition coil to the engine with an
air gap of .38 mm
(.015 in.).
2.
If the engine is a BBC model, mount the kill
wire retainer to the mounting screw on the
carburetor side of the engine.
If the engine
is zone start, mount the kill wire retainer on
the muffler side of the engine. See Fig. 4-63.
Figure 4-63
2. The air gap on the alternator coil is not
adjustable.
3. Be sure to route the alternator wire through
the rubber grommet. Take care not to pinch
the wire behind the starter motor.
4. Mount the starter motor on its bosses with
two screws.
Muffler
1. Install a new gasket on the muffler studs.
2. Install the muffler and secure it with two
nuts tightened to
1.0 1.6 kg-m (7.0
3. Make sure the exhaust pipe faces toward
the spark plug end of the engine when
mounting. See Fig. 4-65.
1 1.5 ft-l bs).
Figure 4-65
35