Service Manual

Muffler and Cooling Shroud
1. Mount the muffler shroud with two screws
only.
2. Mount the cooling shroud and secure it with
three screws.
Do not install the screw
through the oil fill tube at this time.
3. Install the third screw through the muffler
shroud and cooling shroud.
Air Cleaner
1. Place a metal gasket on the carburetor
studs. The rib on the gasket goes away from
the carburetor and toward the air cleaner.
2. Mount the air cleaner as shown in Fig. 3-2.
Fuel Tank
1. Route the fuel hose behind the governor
arm.
2. Connect the fuel hose to the carburetor.
3. Mount the fuel tank with two screws.
Recoil Starter
1. Mount the recoil starter with four screws.
2. Make sure the starter handle points toward
the air cleaner side
of the engine.