Service Manual

Handle Assembly lnstallatlon (cont'd)
3. Bring the handle up into position and secure with
the handle latches.
NOTE: The handle latches should be on the
inside of the handle. For convenience, adjust to
the center hole on the handle latches.
4. Install the control panel into position at the top of
the handle and secure with four self-tapping
screws.
5. Lift the control bar and safety control mechanism
into position at the top of the handle. Secure the
right side of the control bar
with the handle screw,
the support spacer and the locknut.
6. BBC Models:
With the BBC control box
in its proper position
and the temporary fasteners still installed
through the control box, force the
two left hand
handle screws through the handle
in the BBC
control box. This will force out the temporary
fasteners and will insure that no BBC control
box components come loose. Secure the
larger handle screw with a washer and nylon
locknut and the smaller handle screw with just
a locknut.
Handle
Assembly
7.
Zone Start Units:
Bring the control bar assembly into position at
the top of the handle and insert the handle
screws through either side
of the handle.
Secure with the nylon locknuts. Make sure
the
brake cable and the traction cable are properly
positioned
in the short block, then, if
necessary, reinsert them into the traction lever
and the control lever
on the control bar. Before
tightening the cable support bracket, adjust
the brake and traction cable as described in
the Maintenance Section.
Secure the cables to the handle with cable ties
in the locations shown in Figure 122.
-~~-
~__I
Figure 122