Installation Instructions

Figure5
1.Slots(centerandleftof
center)
6.Forward-mountingange
(cablechute)
2.Locknut(10mm)7.Square-tubespacer
3.Supportbracket8.Hole—forward-mounting
ange(cablechute)
4.Bolt(10x25mm)9.10mm(13/32inch)drillbit
5.Flanged-headbolt(10x
70mm)
2.AlignthecablechutetothecanopyoftheROPSframe
withthesupportbrackettotherearofthecanopy
(Figure5).
3.Aligntheholesinthesupportbracketforthecable
chutewiththeholesthatyouidentiedinstep1;refer
toBinFigure5.
4.Assemblethesupportbrackettothecanopywith2
bolts(10x25mm)and2locknuts(10mm)andtighten
theboltsandnutshandtight;refertoBinFigure5.
DrillingHolesintheHeadlightShroud
1.Alignthesquare-tubespacerbetweenthe
forward-mountingangecablechuteandthefront
headlightshroudasshowninCofFigure5.
2.Aligntheholesinthemountingangeofthecable
chuteandthesquare-tubespacerbyinsertingthe2
anged-headbolts(10x70mm)throughtheholes,
refertoCinFigure5
3.Remove1anged-headboltandusetheholesinthe
angeandtubeasadrillingtemplatetodrilla10mm
(13/32inch)holeintotheheadlightshroud;referto
DinFigure5.
4.Inserttheanged-headboltthroughtheholesinthe
cablechutemountingange,square-tubespacer,and
headlightshroud;refertoCinFigure5.
Note:Theboltshouldalignthecablechute,
square-tubespacer,andheadlightshroud.
5.Removetheotheranged-headboltandusetheholes
intheangeandtubeasadrillingtemplatetodrilla10
mm(13/32inch)holeintotheheadlightshroud;refer
toDinFigure5.
6.Removetheboltandsquaretubespacer.
4