Installation Instructions

1
PreparingtheMachine
NoPartsRequired
Procedure
1.Movethemachinetoalevelsurface.
2.Settheparkingbrakeandlowertheattachmentsto
theground.
3.Stoptheengineandremovethekey.
2
AssemblingtheSupport
BrackettotheChute
Partsneededforthisprocedure:
1
Cablechute
1
Supportbracket
2
Flanged-headbolt(10x25mm)
2
Locknut(10mm)
Procedure
1.Aligntheholesonthesupportbrackettotheholesin
themountingangesofthecablechute(Figure1).
Note:Usetheholesateitherendofthechute.
Figure1
1.Cablechute3.Supportbracket
2.Flanged-headbolt(10x
25mm)
4.Locknut(10mm)
2.Assemblethebrackettothechutewiththe2
anged-headbolts(10x25mm)and2locknuts(10
mm)andtightenthenutsandboltshandtight(Figure
1).
3
RemovingtheHeadlightCover
(MachineswithouttheWork
LightKit)
NoPartsRequired
Procedure
1.Attheleftfrontheadlightcover,removethe2
anged-headboltsthatsecuretheheadlightcoverto
thefront-headlightshroudoftheROPSframe.
Figure2
1.Headlightcover
3.Clipnut(headlightshroud
ange)
2.Flanged-headbolts
2.Removethecoverfromtheshroud.
Note:Retainthecoverand2hex-headboltsfor
installationin6InstallingtheHeadlightCover
(MachineswithouttheWorkLightKit)(page5).
2