Installation Instructions

1.Ensurethatthestabilizershoesaresettothewide
position;refertoSettingtheShoePositiononthe
Stabilizer(page33).
2.Digaserviceholedownwherethecablewilljointhe
serviceconnectiontotheplowingdepthofthecable
run(Figure85)andnowiderthan0.6m(24inches).
Note:Thetractionunitcandriveovera0.6m
(24-inch)hole.
Figure85
1.Servicehole2.0.6m(24inches)
3.Plowdirectlytotheserviceholewherethecablesjoins
theserviceconnection(Figure86).
Figure86
1.Servicehole
2.Loopinthecable
4.Beforethebladeenterstheservicehole,stopthe
blade-vibrationfunctionbymovingthevibratory
plow/trenchermotorjoysticktotheNeutralposition.
5.Movethevibratoryplowbladeacrossthehole(Figure
86).
6.Feedthecabledownthroughthechute,andmakea
loopinthecableatthebottomofthehole(Figure86).
7.Whilefeedingthecableintothechute,movethe
tractionunitforwarduntilthebladeentersthesoilon
theothersideoftheservicehole(Figure86).
8.Asthebladeentersthesoil,slowlystartthe
blade-vibrationfunctionbymovingthevibratory
plow/trenchermotorjoysticktowardyou;referto
UsingtheVibratoryPlow/TrencherMotorJoystick
(page30).
Important:Donotstarttheblade-vibration
functionoftheplowuntilthebladehasentered
theground.
PlowingTurnswithaRadiusLessThan0.9m(36
inches)
1.Atthelocationwherethecablewillturn,digaservice
holedowntotheplowingdepth(Figure85)ofthe
cablerunandnowiderthan0.6m(24inches).
2.Plowthecabletothehole(Figure87).
Figure87
1.Cable-plowrun#12.Cable-plowrun#2
3.Beforethebladeentersthehole,stopthe
blade-vibrationfunctionbymovingthevibratory
plow/trenchermotorjoysticktotheNeutralposition;
refertoUsingtheVibratoryPlow/TrencherMotor
Joystick(page30).
4.Selecttheswing-oatswitch(Figure83)totheOff
position;refertoUsingtheSwing-oatSwitch(page
31).
5.Whenthecablechuteofthebladeisintothehole,
performthefollowing:
A.Stopthetractionunit.
B.Removethegatefromthechuteoftheplowblade.
C.Removethecablefromthechute.
D.Carefullyraisethebladeoutofthehole
Note:Donotcutordamagethecablewhileraising
thebladeoutofthehole.
37