Installation Instructions

InstallingtheTrim-CylinderHoses
1.Routethetrim-lefthosefromtheretractportofthe
right-trimcylindertotheconnectorttinginportB3
oftheauxiliary-hydraulicmanifoldandconnectthe
hosetothettinghandtight(Figure46).
Figure46
1.Clampblock(tiltcylinder)4.Trim-lefthose
2.Clampblock(right
swing-frameplate)
5.PortA3
(auxiliary-hydraulic
manifold)
3.Trim-righthose6.PortB3
(auxiliary-hydraulic
manifold)
Figure47
1.Retractport(right-trim
cylinder)
4.Trim-righthose
2.Extendport(right-trim
cylinder)
5.Clampblock(trail-frame)
3.Trim-lefthose6.Clampblock(tiltcylinder)
2.Insertasquarenut(5/16inch)intotheslotintheclamp
supportlocatedontherightsideofthetrail-frame
plate(Figure48).
Figure48
1.Clampsupport(trail-frame
location)
5.Bolt(5/16x2-3/4inch)
2.Squarenut(5/16inch)6.Washer(5/16inch)
3.Clampblock(2-hose)7.Coverplate
4.Trim-lefthose
8.Trim-righthose
3.Routethetrim-righthosefromtheextendportofthe
right-trimcylindertotheconnectorttinginportA3
ofthemanifold,andconnectthehosetothetting
handtight(Figure46).
4.Atthetiltcylinder,alignthetrim-leftandtrim-right
hosesintotheclampblocks(Figure49)thatyou
installedinstep7ofInstallingtheTilt-CylinderHoses
(page21)andtightenthebolt(5/16x2-3/4inch)to
1978to2542N-cm(175to225in-lb).
Figure49
1.Trim-lefthose4.Coverplate
2.Trim-righthose
5.Washer(5/16inch)
3.Clampsupport(tilt-cylinder
location)
6.Bolt(5/16x2-3/4inch)
5.Attherightswing-frameplate,alignthetrim-leftand
trim-righthosesintotheclampblocks(Figure50)that
youinstalledinstep8ofInstallingtheTilt-Cylinder
23