Operator's Manual
Table Of Contents
- NO TITLE
- .
- 1 Preparing to Install the Attachment onto the Machine
- 2 Installing the Backhoe Frame and Swing Tower onto the Machine
- 3 Installing the Backhoe Wiring Harness
- 4 Installing the Walkway to the Machine
- 5 Connecting the Controls to the Wiring Harness
- 6 Installing the Controls Cover and the Panels
- 7 Installing the Stabilizers
- 8 Installing the Stabilizer Hydraulic Cylinders
- 9 Installing the Boom
- 10 Installing the Boom Hydraulic Cylinder
- 11 Connecting the Hydraulic Pressure and Return Hoses
- 12 Bleeding the Stabilizer Cylinders
- 13 Connecting the Hydraulic Hoses to the Boom Hydraulic Cylinder
- 14 Bleeding the Boom Elevation Cylinder
- 15 Installing the Dipper
- 16 Installing the Dipper Hydraulic Cylinder
- 17 Installing the Bucket
- 18 Connecting the Hydraulic Hoses to the Dipper and Bucket Hydraulic Cylinders
- 19 Bleeding the Hydraulic System
- 20 Testing the Operator-presence Switch and the E-stop Switch
- 21 Lubricating the Stabilizers
- NO TITLE
- NO TITLE
- NO TITLE
- NO TITLE
InstallingtheHandRail
Securethehandrailtothewalkwaywith2bolts(M12x40
mm)and2locknuts(M12)asshowninFigure10.
Figure10
1.Bolts(M12x40mm)3.Locknuts(M12)
2.Handrail4.Walkway
5
ConnectingtheControlstothe
WiringHarness
Partsneededforthisprocedure:
1E-stopswitch
1
Operator-presenceswitch
Procedure
1.Removethe4bolts,4washers,and4nutsthatsecure
thecontrolscovertotheoperatorpedestalofthe
backhoe,thenremovethecover(Figure11).
Figure11
1.Operatorpedestal4.Bolt(4)
2.Controlscover5.Nut(4)—notshown
3.Washer(4)
2.Routethebackhoewiringharnessalongtheleft
hydraulictubealongtheoperatorplatform.
3.Routetheharnessupundertheconsoleasshownin
Figure12.
Figure12
Frontview
1.Backhoewiringharness
4.Routethebranchoftheharnesswitha2-socket
connectorthroughtheseat-posttube(Figure13).
11