Operator's Manual

B.RemovethescrewthatsecurestheE-stopbutton
totheE-stopswitch,andremovethebutton
(Figure31).
C.RemovetheC-clipandthejamnutfromthebody
oftheE-stopswitch(Figure31).
2.InstalltheE-stopswitchasfollows:
A.Locatethealignmenttangonthebodyofthe
E-stopswitch(Figure32).
Figure32
1.E-stopswitch
6.C-clip
2.Alignmenttang
7.Groove
3.Notchinthehole8.E-stopbutton
4.Jamnut
9.Screw
5.Squaretting
10.Buttoncover
B.Aligntheswitchfromtheinsideofthecontrol
coverandthroughtheholeintheupperright
corner(Figure32).
Note:Ensurethatthealignmenttangonthe
E-stopswitchalignswiththenotchinthehole
fortheswitch.
C.Securetheswitchtothepanelwiththejamnut
(Figure32)thatyouremovedinstep1-C.
D.InstalltheC-clip(Figure32)thatyouremoved
instep1-Cintothegrooveinthebodyofthe
E-stopswitch.
E.AlignthesquarerecessinthebackoftheE-stop
buttontothesquarettingoftheE-stopswitch.
F.SecuretheE-stopbuttontotheswitchwiththe
screw(Figure32)thatyouremovedinstep1-B.
G.Installthebuttoncover(Figure32)thatyou
removedinstep1-Aintothescrewpocketinthe
E-stopbutton.
12
InstallingtheControlsCover
andthePanels
NoPartsRequired
Procedure
1.Aligntheholesofthecontrolscoverwiththeholesin
theoperatorpedestalofthebackhoe(Figure26).
2.Addmedium-grade(serviceremovable)thread-locking
compoundtothe4boltsthatyouremovedinstep1of
10RoutingandConnectingtheWiringHarnessonto
theBackhoe(page19).
3.Securethecovertothepedestalwiththe4boltsand4
washers(Figure26)thatyouremovedinstep1of10
RoutingandConnectingtheWiringHarnessontothe
Backhoe(page19).
4.RotatethebatterydisconnecttotheOnposition;refer
tothetractionunitOperator’sManual.
5.Installtheleft-andright-sidepanelsandthenose
panel;refertothetractionunitOperator’sManual.
22