Operator's Manual

10
RoutingandConnectingthe
WiringHarnessontothe
Backhoe
NoPartsRequired
Procedure
1.Removethe4boltsand4washersthatsecurethe
controlscovertotheoperatorpedestalofthebackhoe,
andremovethecover(Figure26).
Figure26
1.Operatorpedestal
3.Washer
2.Controlscover
4.Bolt
2.Routethebackhoeharnessupwardandalongthe
2leftmosthydraulichosesatthebackplateofthe
backhoe(Figure27).
Figure27
1.Backhoewiringharness
5.Console-supportplate
(left)
2.Forward
6.Console-supportplate
(right)
3.Two-socketconnector7.Hydraulichoses
4.Seat-posttube
8.Hydraulic-bulkheadplate
3.Routetheharnessupwardandbetweentheleftand
rightconsole-supportplatesoftheoperatorpedestal
(Figure27).
4.Routethebranchoftheharnesswitha2-socket
connectorthroughthetubeoftheseatpost(Figure27).
5.Connectthe2-socketconnectorofthebackhoewiring
harnesstothe2-pinconnectoroftheoperatorpresence
switch(Figure28).
Note:Ensurethatthereisenoughslackinthebranch
oftheharnessfortheoperator-presenceswitchatthe
forwardendoftheseatpost.
Figure28
1.Operator-presenceswitch
2.Two-pinconnector,
backhoewiringharness
20