Operator's Manual

Figure7
1.Bulkheadplate3.Engine-oildraincap
2.Backhoewiringharness
3.Routethewiringharnessupthroughthehorizontal
accessholeinthepivotplateforthebackllblade,
whichislocatedinfrontoftheradiator(Figure8).
Figure8
1.Backhoewiringharness3.Hydraulicbulkheadplate
2.Accesshole
4.Routethewiringharnessforwardthroughthehydraulic
bulkheadplateandthenforward(Figure8).
5.Installthenosepanelandtheleftandrightsidepanels;
refertothetractionunitOperator’sManual.
Note:Ensurethatthebackhoewiringharnessis
locatedunderthebottomofthenosepanelandin
frontofthepanel.
6.Laythebackhoewiringharnessoverthefrontandtop
ofthenosepanel,andtemporarilysecuretheharness
ontothepanelwithapieceofadhesivetape.
3
InstallingtheMountingPlates
totheMachine
Partsneededforthisprocedure:
1
Leftmountingplate
1Rightmountingplate
4
Bolt(1-1/4x3-1/2inch)
4
Washer(1-1/4inch)
Procedure
Note:Theweightofeachmountingplateweightis40.4kg
(89lb).
1.Aligntheleftandrightmountingplatestotheir
respectivefrontattachmentmountingpointsonthe
frameofthemachine(Figure9).
Figure9
1.Rightmountingplate4.Mountingpoint
2.Bolt(1-1/4x3-1/2inch)5.Leftmountingplate
3.Washer(1-1/4inch)
2.Attacheachmountingplatetothemachinewith2bolts
(1-1/4x3-1/2inch)and2washers(1-1/4inch),and
tightenthefastenersbyhand(Figure9).
Note:Youwilltorquetheboltsthatsecurethe
mountingplatestothemachineinstep9of4Installing
theBackhoeandtheBracketsontotheMachine(page
11).
11