Service Manual

Figure 4-57
Breather
1. Install the reed plate assembly.
2. Make sure there is a gasket underneath and
on top
of the reed plate.
3. Install the cover plate. Use two 6 mm screws
that are 12 mm long. If longer screws are
used, the block may be damaged. Torque
the screws to .4
.7 kg-m (3.0 5.0 ft-lbs).
See Fig. 4-58.
Figure 4-58
Flywheel
1. Inspect and install the key. Inspect and
clean the crankshaft and flywheel tapers.
Place the flywheel on the crankshaft.
2. Mount the starter cup with three screws.
3. Mount the flywheel nut and torque it to 5.6
-6.4 kg-m (40.5 46.5 ft-lbs).
Throttle Control and Carburetor
1. Mount the throttle control assembly to the
engine block with twoscrews. See Fig. 4-59.
Figure 4-59
2. Install the throttle control arm (governor
arm) on the governor shaft do not tighten
the retaining nut at this time. See Fig. 4-60.
Figure 4-60
3. Connect the throttle control rod, choke rod
and governor spring as shown in Fig. 4-59.
4. Mount a gasket, spacer and gasket on the
carburetor mounting studs.
5. Hook the throttle control rod and spring into
the throttle shaft on the carburetor.
6. Mount the carburetor on its mounting studs.
See Fig. 4-61.
34