Operator's Manual

Setup
LooseParts
Usethechartbelowtoverifythatallpartshavebeenshipped.
ProcedureDescription
Qty.
Use
Handle1
Hex-head-angebolt(5/16x1-1/2
inches)
2
Carriagebolt(5/16x1-1/2inches)
2
1
Flangenut(5/16inch)
4
Installthehandle.
2
Nopartsrequired
–
Fillthecrankcasewithoil.
3
Nopartsrequired
–
Adjusttheself-propeldrive.
Note:Determinetheleftandrightsidesofthe
machinefromthenormaloperatingposition.
1
InstallingtheHandle
Partsneededforthisprocedure:
1Handle
2
Hex-head-angebolt(5/16x1-1/2inches)
2
Carriagebolt(5/16x1-1/2inches)
4
Flangenut(5/16inch)
Procedure
1.Removethecableguardfromthehandle(Figure
3)byremovingthe2carriageboltsand2
locknutsthatholdthecableguardtothehandle.
g024306
Figure3
1.Cableguard4.Flangenut—5/16inch(2)
2.Locknut(2)5.Hex-head-ange
bolt—5/16x1-1/2inches
(2)
3.Carriagebolt—1/4x1-1/2
inches(2)
Note:Savetheguard,thecarriagebolts,and
thelocknutssothatyoucaninstallitontothe
handlelaterinthisprocedure.
2.Installthehandleendsontothemowerhousing
with2hex-head-angebolts(5/16x1-1/2
inches)and2angenuts(5/16inch)asshown
inFigure3.
3.Setthemachinetothedesiredcuttingheight;
refertoAdjustingtheCuttingHeight(page11).
7