Service Manual

3-16 FUEL SYSTEM
Priming Pump
PrimingPumpRemoval
•
Remove the tube [A] from the priming pump.
•
Remove the nut [B] and washer [C].
•
Remove the priming pump from the intake manifold.
•
Inspect the priming pump for damages.
If a damage is present in the priming pump, replace it.
Priming Pump Installation
•
Install the priming pump in the intake manifold.
•
Install the washer [A] and tighten the nut [B].
Torque - Priming Nut: 1.2 N·m (0.12 kgf·m, 11 in·lb)
•
Install the tube [C] on the priming pump.
•
Install the tube [B] on the primer pipe [A] as shown.
8 ~ 10 mm [C]