Service Manual

FUEL SYSTEM 3-9
Governo r Link Mechanism
Governor Assembly Installation
•
Instal the sleeve [A] on the governor assembly [B].
CAUTION
First install the sleeve. The sleeve cannot be in-
stalled after the governor gear assembly has been
installed.
•
To install, first place the thrust washer [C] on the boss of
the shaft [ D]. Then, install the governor assembly (with
the sleeve attached) on the shaft so that step [E] is fitted
securely in groove [ F].
•
After installing the assembly, turn the governor by hand
to make sure that the governor weight [G] and the sleeve
move smoothly.
Governor Shaft Removal
•
Remove:
Air Cleaner (see Fuel System chapter)
Recoil Starter (see Electrical System chapter)
Fuel Tank (see Fuel System chapter)
Governor Arm (see Governor Arm Removal)
Flywheel (see Electrical System chapter)
Crankcase Cover (see Camshaft/Crankshaft chapter)
Crankshaft (see Camshaft/ Crankshaft chapter)
•
Remove:
Snap Pin [A]
Governor Shaft [B]
Washer [C]
Governor Shaft Installation
•
Apply engine oil to the governor shaft.
•
Install:
Washer [A]
Governor Shaft [B]
Snap Pin [C]
•
Check t hat the governor shaft moves freely in its operating
range.