Operator's Manual

Figure 50
1. Brake uid reservoir 2. Minimum line
Adjusting the Parking Brake
Chec k the parking brak e adjustment ev er y 200
hours .
1. Pr y the r ubber co v er off of the parking brak e .
2. Loosen the set screw securing the knob to the
parking brak e lev er ( Figure 51 ).
Figure 51
1. Parking brake lever
3. Set screw
2. Knob
3. R otate the knob until a force of 30-35 lb
(133-156 N) is required to actuate the lev er .
4. Tighten the set screw and install the r ubber
co v er .
Belt Maintenance
Servicing the Drive Belt
Checking the Drive Belt
Chec k the condition and tension of the dri v e
belt after the first da y of operation and ev er y
200 operating hours thereafter .
1. P ark the mac hine on a lev el surface , shift into
Neutral, set the parking brak e , tur n the ignition
off , and remo v e the k ey .
2. Raise the bed and secure it with the prop rod.
3. R otate and inspect the belt ( Figure 52 ) for
ex cessi v e w ear or damag e . R e place the belt if
necessar y .
Figure 52
1. Drive belt 3. Secondary clutch
2. Primary clutch
Replacing the Drive Belt
1. R otate and route the belt o v er the secondar y
clutc h ( Figure 52 ).
2. R emo v e the belt from the primar y clutc h
( Figure 52 ).
3. T o re place the belt, rev erse the procedure .
Cleaning
Washing the Vehicle
T he v ehicle should be w ashed as needed. Use
w ater alone or with a mild deterg ent. A rag ma y
be used, ho w ev er the hood will loose some of its
luster .
Important: Pr essuriz ed w ater is not
r ecommended when w ashing the machine.
It may dama ge the electrical system, loosen
impor tant decals, or w ash a w ay necessar y
g r ease at friction points. A v oid ex cessi v e use
of w ater , especiall y near the contr ol panel,
engine, and batter y .
39