Service Manual

49
49
CAMSHAFT
2. Check cam lobe height with vernier calipers,
If lobe height
is less than 22.80 mm (0.898 in.).
replace camshaft.
E35FC08W2
1. Place cyl. block upside down on bench.
2. Install tappets in their respective positions and push
them all the way into guide to avoid interference with
camshaft in assembling.
3. Rotate crankshaft until piston is at highest position.
4. Aligning timing marks (A) and (B), install camshaft
into crankcase.
E35FCOSWI