Service Manual
13
CONTROL
SYSTEM
13
Whenever carburetor
or
governor lever
is
removed from engine
and then installed again. adjust governor lever position.
Install governor lever
(A)
on governor shaft
(B)
but do
not tighten nut (C).
Loosen nut
(C)
if it is tightened.
Turn governor lever
(A)
counterclockwise
or
place
throttle lever on dash in
"FAST*
position to open carb.
throttle valve fully.
Turn governor shaft
(B)
counterclockwise to end
of
travel.
Keeping governor lever position of throttle fully open,
tighten nut
(C).
Link throttle cable
(G)
to speed control lever
(C)
and
clamp throttle cable outer housing
(F)
temporalily.
With throttle lever on dash in "FAST" position, align
hole
(B)
of
speed control lever
(C)
with hole
(D)
of
control plate
(E)
and insert
6
mm
(0.24
in.) dia. pin
or
6
mm bolt through two holes.
Pull
out throttle cable outer housing
(F)
to remove
any slack and tighten cable clamp bolt
(A).
Remove
6
mm pin and set throttle lever on dash in
"CHOKE* position. Make sure carb. choke valve
is
corn-
pletely closed. (See CHOKE ADJUSTMENT)
~~
E
I6FCO6W2
E
16FCO?W2